Aquaseal® & Cotol-240™
Flexible Adhesive and Cure Accelerator for Fast, Permanent Repairs
Some things are made for each other, like Cotol-240™ Cure Accelerator and Aquaseal® repair adhesive by M Essentials™. Aquaseal repairs tears and rips in dive equipment and watersports gear. Cotol-240 improves those repairs by cleaning the surface and speeding dry time to two hours.
Don’t let a rip or a tear stop you. Repair it fast with a combination of Aquaseal and Cotol-240 and keep your gear going as long as you do.
- Flexible urethane repair adhesive and cure accelerator
- Industry standard for maximum strength repairs to dive equipment and watersports gear
- Cotol-240 removes tar, sap, glue and other resins
- Aquaseal® repairs rips, tears, holes in outdoor gear
- Specifically formulated to offer superior flexibility as well as excellent adhesion, waterproofing and abrasion resistance with minimal shrinkage
- Cure time in less than two hours; tack time in 15 minutes
When cured (dry) Aquaseal is a thick, clear, elastic urethane rubber.
How it works? –
Aquaseal is applied to a hole or tear and allowed to cure over a period of hours (usually 8-12).
When applied, Aquaseal cures by reacting with humidity in the air. It doesn’t ‘dry’ the way other glues do. It changes from a thick liquid to a thick, flexible, elastic rubber.
Once cured, it’s permanent. The repair will generally last the life of the item.
Clean damaged area with Cotol-240™ Cure Accelerator/Precleaner or solvent (paint thinner, nail polish remover or similar).
Trim loose threads. Non-fabric surfaces should be roughened with sandpaper, then cleaned. Apply Aquaseal® to surfaces directly from tube or with knife or flat stick. Keep repair level overnight. Avoid contact with other surfaces.
Most repairs reach full strength overnight (10-14 hours). Allow longer for thickest repairs. For fastest cure (2 hours or less), mix in Cotol-240.
HOLES AND TEARS: Create backing with removable tape. Fill void and 1/4" beyond edge with Aquaseal. Remove tape after full cure.
SEAMS: Apply 1/16" thick bead overlapping seams edges by at least 1/4". Apply with slight pressure to saturate fabric surfaces.
HIGH WEAR AREAS: Apply thin coat with knife for flexible abrasion resistance.
WARNING: FULLY CURED AQUASEAL IS SLIPPERY WHEN WET. For added traction on footwear, sprinkle sand on uncured Aquaseal 1/2 hour after applying.
CLEAN UP: To remove Aquaseal from hands, buff with cloth soaked in paint thinner, nail polish remover or 99% isopropyl alcohol.
STORAGE: Advance contents to tube neck. Wipe clean and cap. Keep in cool, dry place; for extended life, place in freezer. To thaw or for easier-flowing contents, soak tube in warm water for 15 minutes.